ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
Key Features
-
5 V power supplied by a USB connector
-
USB 2.0 full speed compatible interface
-
USB standard A to mini B cable
-
SWIM specific features
-
1.65 V to 5.5 V application voltage supported on SWIM interface
-
SWIM low-speed and high-speed modes supported
-
SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
-
SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012)
-
SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
-
JTAG/serial wire debugging (SWD) specific features
-
1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs
-
JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
-
JTAG supported
-
SWD and serial wire viewer (SWV) communication supported
-
Direct firmware update feature supported (DFU)
-
Status LED which blinks during communication with the PC